Engine Overhaul Manual
Jabiru Aircraft
Pty Ltd
Jabiru 2200 & 3300 Aircraft Engines
This document is controlled while it remains on the Jabiru server. Once this no longer applies the document becomes uncontrolled.
ISSUE
1
2
3
4
5
6 7
Dated : 28/10/2014
Issued By: AS
Page: 35 of 201
L:\files\Manuals_For_Products\Engine_Manuals\Overhaul_Manual\JEM0001-7_Overhaul_Manual_DRAFT_(29_10_14).docx
Figure 35
– Crankcase Dowel Remover
Figure 36
– Crankshaft Welch Plug Installer / Remover
Figure 37
– Die-Grinder Flapper Wheel For Little End
Figure 38
– Universal Joint tool FU14B
Snap-On tool FU14B
– a universal joint with inbuilt 7/16” nut drive. Used for changing through-bolt nuts
without removing cylinder heads.
FU16B is the equivalent part with ½” socket for use on 7/16” 12-point nuts.
Essentially a long, large punch used to both remove and
install the welch plugs from the ends of the crankshaft.
An adapted puller used to remove the dowel pins from the
crankcase halves.
A standard sandpaper “Flapper Wheel” for a Die Grinder
shaped to fit inside the connecting rod little end to remove
burnt oil deposits.