T
RANSPORT AND STORAGE
4. Transport and storage
4.1. Safe transportation
NOTICE
Note the weight (approx. 550kg (1231lbs) for
standard lift of 3m (10 ft), each 1m (1ft) of ad-
ditional lift increases the weight by 2x 12,2kg
(2x 8.2lbs)) of your product
PROFI 25 TI
during
transport. Ensure that the control system is not
damaged. This could lead to malfunctions.
If you want to transport your product
PROFI 25 TI
to another site of application, please observe the
following points:
1. Reel the chain so that so that no loops can
form and the chain cannot become twisted.
2. Depressurise the power supply and close
lines so that no dirt can enter.
3. Carefully set the hoist down and do not allow
it to fall.
4. Secure the chain.
5. Lay the control and supply hoses together so
that they are not kinked
4.2. Storage conditions
4.2.1. Breaks in operation
1. Bring the load hook / clevis into the upper end
position. Ensure that the lifting limiter is not
triggered.
2. Depressurise the power supply.
3. In the event of longer breaks in operation,
coat the chain and hook / eyelets with a light
oil film.
4. Motor conservation: If the motor lubrication
is not renewed at the specified intervals, a
protective coating must be applied to the mo-
tor. For this purpose, use a non-resinous and
non-sticky conserving oil with a conserving
protection duration that corresponds to the
length of the planned operational break.
4.2.2. Storage
1. Close off the energy supply connection pieces
with a suitable cap in order to prevent dirt
ingress.
2. Protect all connections from damage.
3. Store JDN product in a dry and clean location.
Doc.-No.: VA049318-10-OM-EN-0319-64-2
Page
27
of 64
