IXXAT Econ 100, Руководство по оборудованию, Страница: 14 / 22

Connections and displays

Link
Color Mode Status
yellow off No connection to the Ethernet network
yellow on Link available

Activity
Color Mode Status
green off No network activity
green Flashing Network activity
The link speed is not shown.
3.3.8 LAN 2 LEDs
The two LEDs built into the RJ45 connector are used to indicate the status of
the LAN 2 Ethernet port. The green LED shows the link status and the activity,
the yellow LED shows the link speed.

Link/Activity
Color Mode Status
green off No connection to the Ethernet network
green on Link available
green Flashing Network activity

Speed
Color Mode Status
yellow off 10MB/s operation
yellow Flashing 100MB/s operation
3.3.9 Port 0/Port 1 LEDs
The two LEDs built into the RJ45 connector are used to indicate the status of
each Ethernet port. The meaning of the LEDs depends on the Industrial Ether-
net protocol in use.
3.4 Internal connections
Additional interfaces are implemented on the circuit board that are not led out-
side and are only accessible with the housing open. These can be seen in
Figure 3-11.
Copyright IXXAT Automation GmbH
14
IXXAT Econ 100 hardware manual,
version 1.3