Brushless Motor / Impeller
Brushless Motor
- The brushless motor is located
directly below the Top Deck. 4 bolts run down through
the Top Deck and into the housing of the brushless
motor fastening it onto the machine.
The brushless motor is built to be very durable. The
housing is constructed of casted aluminum. The
brushless motor runs very quietly and smoothly. It
does not require any maintenance. A drive shaft
extends through the bottom center of the housing.
CAUTION: THE BRUSHLESS MOTOR WEIGHS
APPROXIMATELY 80 LBS (36KG). DO NOT
REMOVE WITHOUT DISCUSSING THE
PROCEDURES AND EQUIPMENT NECESSARY
WITH A SERVICE TEAM MEMBER.
Shaft Coupling
- The shaft coupling connects the
brushless motor drive shaft to the impeller shaft. The
shaft coupling is located directly below the brushless
motor and is made up of 3 main components. These
components are called the upper coupling, lower
coupling, and coupling sleeve. The shaft coupling is
designed to allow quick disconnect for removal of the
impeller assembly. Disconnecting the impeller shaft
from the brushless motor shaft is simply accomplished
by pulling out a pin and requires no tools. The upper
coupling remains attached to the brushless motor while
the lower coupling and coupling sleeve remain on the
impeller shaft.
Brushless Motor
Upper Coupling
Lower Coupling
Coupling Sleeve
Clevis Pin
©2022 IXOM Watercare Inc. | www.ixomwatercare.com | 866 - 437 - 8076 | [email protected]
Features
Features
SB and GF Large Frame Mixers
10267_20220110
O&M_GF2500_10115_20220121 - 6
