SCADA outputs offering machine operation parameters
reside within the digital controller. Please contact us if
you are interested in receiving these parameters.
Motor Controller
- The motor controller is located near
the motor just below the top plate of the Machine. The
motor controller is sealed in line with the electrical cord
that runs to the brushless motor.
The motor controller on the Machine receives power
and signals from the main control center located inside
the external enlosure. These signals are used to
operate the brushless motor at the commanded speed.
The motor controller also sends feedback signals back
up to the main control center.
Due to the high frequency of communication between
the motor controller and brushless motor, the two
components need to be located close to one another.
This is the primary reason for having the motor
controller located directly on the Machine.
All electronic connections on the Machine equipment
should only be used for the inputs or outputs that they
are labeled and designed for. If any of the leads going
into the electronic controller are disconnected, be
sure when re-connecting to place them in the proper
position.
Wiring -
All electric wiring includes corrosion-resistant,
industrial cords with molded, weather and watertight
connectors. The connectors are indexed to prevent
improper wiring. A general electrical schematic can
be found in the Maintenance and Field Adjustment
section.
Motor Control Cord
Durable Wiring And Connectors
©2022 IXOM Watercare Inc. | www.ixomwatercare.com | 866 - 437 - 8076 | [email protected]
Features
Features
SB and GF Large Frame Mixers
10267_20220110
O&M_GF2500_10115_20220121 - 5
