IXIA BreakingPoint Storm, Руководство по установке

Страница: 28 / 62

FireStorm ONE Installation Guide 19 BreakingPoint Systems Inc. ©2005-2016
Figure 2-5:
Defining a Subnet
To define a non-VLAN subnet:
1. Select Control Center > Network Neighborhood from the BreakingPoint Control Center
Menu bar.
2. Select a Network Neighborhood from the Network Neighborhoods list.
3. Select a test interface to modify by clicking the Interface tab.
4. Select a domain from the Domains list.
5. Click the Show the create new subnet form (‘+’) button located under the Subnets list. The
Create new subnet popup dialog box will appear.
Note: If you are adding a subnet to an empty domain, then you can skip this step. The Subnet
form will already be blank and ready for you to input addressing information.
6. Select IPv4 or IPv6 addressing.
7. Click the VLAN Tagging dropdown button and select a VLAN tag.
8. Select Use NAT for network address translation (if applicable).
9. Enter an IP address in the
Network IP Address field. To assign an IPv4 address, use the
format x.x.x.x, where x is a number between 0-255. To assign an IPv6 address, use the format
x:x:x:x where x is a valid hexadecimal value.
10. Enter a mask for the network address in the Netmask field. For IPv6 addressing, enter the
prefix in the Prefix field.
11. Enter a gateway address in the Gateway IP Address field. To assign an IPv4 address, use the
format x.x.x.x, where x is a number between 0-255. To assign an IPv6 address, use the format
x:x:x:x where x is a valid hexadecimal value.
12. Click the Type dropdown button.
13. Do one of the following: