CarKeeper Installation Manual
Main unit’s composition
A.
Power wire
B.
Protection case of car remote with connecting wire
C.
GPS receiver
Power-supply wire connection
1.
Black/Red (right): Car fuse output 12 volts
2.
Black (mid) : to be connected with ACC or IGN fuse or IGN wire
3.
Black (left): Screw tightly onto metal screw on car or chassis
1.
The main unit can be placed in storage compartment at left side of the
driver's seat (location A).
2.
For location of
protection case of car remote
, refer below:
(1)
Push start/stop car: Recommended location is in any detectable place
near
driver’s seat
or
push start/stop button
(location B), to allow best
detection with car computer.
(2)
Key-start car: The location can be any concealed place together with
main unit.
3. The GPS receiver can be placed under the wind-shield (location C).
C
A
B
B
C
A
Power wire
Black/Red
(right)
：
12V(+)
Black
(mid)
：
IGNITION
Black
(left)
：
GND(-)
B
Control wire
(Soldered to car remote’s circuit board )
Pink
：
3V(+)
Black
：
GND(-)
Blue
：
Soldered to trigger point
for unlock button
Green
：
Soldered to trigger
point for lock button
Gray
：
Common point
A
