Ivoclar digital PrograMill Base, Руководство по эксплуатации

Страница: 12 / 144

Safety
12
2.2 Operator’s obligations
The operator is responsible for the safe operation of the device.

Ensure compliance and control:
a. Intended use
b. Statutory or other safety and accident prevention regulations

Only operate the device in a technically perfect condition, in a proper, safety-conscious
and risk-conscious manner and while observing these Operating Instructions.

Keep these instructions and all applicable documents complete, legible and accessible to
personnel at all times.
2.3 Personnel qualifications

Ensure that the personnel assigned to work with the device have read and understood
these instructions and all applicable documents, in particular safety, maintenance and
repair information, before starting work.

Ensure that personnel is aware of hazards and safety equipment (“Working areas,
potential hazards and safety measures on the device”, page 14).

Manage the responsibilities, competence and monitoring of staff.

All work must only be carried out by qualified technical staff.

Personnel to be trained should only carry out work on the unit under the supervision of
qualified technical personnel.
2.4 Staff obligations

Only operate the device in a technically perfect condition, in a proper, safety-conscious
and risk-conscious manner and while observing these Operating Instructions.

Refrain from any process that could endanger staff or third parties.

In the case of safety-related malfunctions, switch off the device immediately and allow the
fault to be rectified by the person responsible.

In all cases of doubt regarding the safety of the device, switch off the device and prevent
further use.

In addition to the overall documentation, legal or other safety and accident prevention
regulations including applicable standards and guidelines of the respective operating
country must be complied with.

Do not wear jewellery such as rings, bracelets or watches when working on the device,
especially when cleaning the milling chamber. Danger of crushing or cutting injuries.