Iveco NEW DAILY, Инструкция по эксплуатации

Страница: 117 / 240

NEW DAILY
–
APPLICATIONS OF SUPERSTRUCTURES
APPLICATIONS OF SUPERSTRUCTURES
3.13 APPLICATION OF A WINCH
31
–
Printed 603.95.789
–
1 Ed. - Base 02/2014
3.13 APPLICATION OF A WINCH
The application of a winch on the vehicle can be carried out at the following points:
●
on the front part of the chassis (frontal);
●
on the chassis of the vehicle, behind the cab;
●
between the side members of the vehicle, in a central or lateral position;
●
on the rear part of the chassis.
The installation must be carried out so as not to alter the correct functioning of the vehicle's assemblies and components, in ob-
servance of the maximum permitted axle limits and following the instructions of the winch manufacturer. The fastening of the idler
members and assembly, must be carried out in observance of Chapter 2.2 (
➠
Page 8), ensuring that the connection areas are not
only reinforced locally (see Chapter 2.17 (
➠
Page 55)), according to the pull of the winch cable and particularly its transverse com-
ponent, when the traction is oblique.
The installation of a winch in the area behind the cab must allow for the insertion of an auxiliary frame, of suitable dimensions and
structure (crossbars and diagonals for stiffening) for the winch capacity.
In the event of winches:
●
hydraulically controlled: previously installed hydraulic pumps can be used for other services (tipping bodies, cranes, etc.);
●
mechanical: for transmission of the control it is necessary to follow the indications contained in Chapter 4.1 (
➠
Page 5) and
4.2 (
➠
Page 7);
●
with worm screw control: the dimensioning of the drive parts must take into account the low efficiency of controls of this
type;
●
electric: these are used for low power applications of brief duration, given the limited capacity of the vehicle battery and al-
ternator.
3.14 SPECIAL OUTFITS
The body builder must ensure compliance of operations carried out with legal requirements, especially in the case of configurations
for the transport of persons.
Cowl chassis versions
They are made specifically for the installation of special bodies or equipment (shop vans, motor homes, etc.).
The indications and precautions shown on the technical documentation (chassis diagram) provided by IVECO must be carefully
respected.
Motor home
Mass limits applicable to single axles must be strictly adhered to, as well as the total limit, keeping in mind a sufficient load margin in
addition to the number of people expected:
●
baggage, tents, sporting equipment;
●
water tank, sanitary facilities;
●
gas cylinders, etc.
It is necessary to ensure that the load to be transported can be placed in specific compartments, with appropriate safety margins
and providing suitable directions.
Special attention must be given to the construction of compartments for gas cylinders, which must be built in compliance with spe-
cific regulations in force and adopting the necessary safety precautions.
For repair operations on the rear overhang, see the instructions in Chapter 2.5 (
➠
Page 19).