background image

 

 

 

IVA UX-4P 

UHF Wireless Microphone 

User Manual 

 

 

 

 

 

 

 

 

Features 

 

Enhanced muting 

 

High signal/noise ratio 

 

Supports both balance & unbalance audio output 

 

Display  panel  show  the  frequency  of  the  microphones  and  the 

volume level it is receiving 

 

Near zero noise output on standby 

 

Broad frequency response range  

 

Low distortion 

 

No  ‘pop’  sound  when  switching  receiver  on/off,  ensure  safety  of 

rear stage amplifier system and speaker 

 

Perfect  operative  status  signals,  fluorescence  display  with  digital 

microphone 

 

Dual  frequency  design  that  allows  two  microphones  to  be  used  at 

the same time without mutual interference 

 

Modern audio compounder preserving tone quality  

 

 

Содержание UX-4P

Страница 1: ...eceiving Near zero noise output on standby Broad frequency response range Low distortion No pop sound when switching receiver on off ensure safety of rear stage amplifier system and speaker Perfect operative status signals fluorescence display with digital microphone Dual frequency design that allows two microphones to be used at the same time without mutual interference Modern audio compounder pr...

Страница 2: ... the operating indicator lights up red it means that the battery is low When it light up green it means that the battery is good When there is no light it means the microphone is off Operation 1 Install batteries 2 Turn on microphones by pushing the switch towards the ON position 3 After you are done singing talking push the switch to the OFF position 4 If you are not going to use the microphone f...

Страница 3: ...respond the negative and positive end of the microphone Push Close the microphone handle bodypack back on Parameter Receiver Oscillation Mode Quartz Controlled Fixed Frequency Carrier Wave Stability 10 PPM Sensitivity 105dB sinad 12 dB S N Ratio 105dB T H D 0 5 1 kHz Image Rejection 85 dB typical Spurious Rejection 75 dB typical Frequency Responses 40Hz 18kHz Working Distance 30 meters at empty sp...

Страница 4: ...ies in the microphone are not properly installed Receiver is not connected to an mixer Operate the machine in the effective range Turn on the microphone switch Turn on the microphone volume Reinstall the batteries Make sure the positive and negative end are install correctly Connect to to cable from the receiver to a microphone input Distorted sound feedback 2 microphones are too close together Ba...

Отзывы: