ITV DLK642Lite, Руководство пользователя

Страница: 26 / 32

26 Integrated Technical Vision Ltd http://www.itvsystems.com.ua
Output time
Press [3] [#] after you have chosen number of the output, the panel reflects
current output time by means of buzzer and LED 3. The panel switches to output
programming mode after
[#] button pushing. To introduce new settings press [*]
then enter time (from 0 sec to 255 sec) + [#] .
0 sec time setting corresponds to 0,2 sec. output engaging.
Output operating mode
Press [4] [#] after you have chosen number of the output, the panel reflects
current output operating mode by means of buzzer and LED 3. The panel
switches to output programming mode after
[#] button pressing. To introduce
new settings press [*] then enter operating mode (from 1 to 4) + [#] .
Outputs operating modes are:
[1] - start-stop. Output with lock type is switched off at opening of the door or at
finishing of door time interval. Output of bell or alarm type is switched off at ending
of door blocking time interval or at breaking and shorting of Blocking or Free pass
input.
[2] - impulse. Output is activated for a time set during programming.
[3] - trigger. Output is activated at each odd command and switched off at each
even command.
[4] - continuous. Lock output is switched at door opened or at finishing of door time
interval. Bel l or alarm output is switched off at ending of door blocking time interval
or at breaking and shorting of Blocking or Free pass input.
For example: It is necessary to set the following parameters for output 1: door A
lock, operating time - 3 seconds, impulse operating mode.
In engineer code programming mode press
[1] [9] [#] (red LEDs 1 and 2 blink
synchronously). Press [1] [#] (red LED1 and yellow LED2 blink alternately).
Press [1] [#] again (red LED1 blinks, buzzer and green LED3 reflect output 1
current type setting. Press [#] to proceed with output attribute setting (red LED1
and green LED2 blink synchronously). Press [1] [#] , new value is accepted (red
LED 2 and yellow LED2 blink alternately). Press [2] [#] (red LED1 blinks, buzzer
and green LED3 reflect current output attribute setting). Press [#] to proceed
with output attribute setting (red LED1 and green LED2 blink synchronously).
Press
[0] [#] , new value is accepted (red LED1 and yellow LED2 blink alter-
nately). Press [3] [#] (red LED1 blinks, buzzer and green LED3 reflect current
time of output 1 engaging). Press [#] to proceed with output time setting (red LED1
and yellow LED2 blink synchronously). Press [3] [#] , new value is accepted (red
LED1 and yellow LED2 blink alternately). Press [#] to proceed with output operating
mode setting (red LED1 and green LED2 blink synchronously). Press [2] [#] , new
value is accepted (red LED1 and yellow LED2 blink alternately).
To proceed with other outputs' programing press
[#] (red LEDs 1 and 2 blink
synchronously). To move to upper menu level press [#] again (red LEDs 1 and 2
blink alternately, LED3 is off).
To switch the panel to main mode press
[#].
40 seconds pause between digits entry causes panel switching to main mode.
Programming the panel in stand-alone use