ITV DLK642Lite, Руководство пользователя

Страница: 21 / 32

http://www.itvsystems.com.ua Integrated Technical Vision Ltd 21
You can change settings by pressing [1] button - relay 1 management switch on/
off, [2] -relay 2 management switch on/off, and [3] - transistor outputs switch on /
off. [#] button pressing returns the panel to current code editing. Then press [#]
to move to the highest menu level.
To exit programming mode press
[#] button.
Day/night mode switch
Press [4] [#] in code parameters programming mode. LED 2 reflects current
parameters settings. Code/card can switch day/night mode if green LED 2 is on.
You can change settings by pressing
[1] button. [#] button pushing returns the
panel to current code/card parameters editing. Press [#] to move to the highest
menu level.
Next
[#] pressing leads exiting programming mode.
Code category
Press [5] [#] being in code parameters programming mode. Green LEDs 2 and
3 reflect current code parameters settings in double code (see Table 1).
You can change settings by pressing
[1] button for category 1, [2] for category 2 ,
[3] for category 3, [4] for category 4. [#] button pressing returns panel to current
code parameters programming. Press [#] to move to the highest menu level.
Next [#] button pressing leads to exiting programming mode.
For example: It is necessary to set access grant to door A, relay 2 management
and permit cardholder switch day/night modes.
Press
[2] [#] in engineer code programming mode (red LEDs 1 and 2 blink) pass a
card, panel proceeds with card settings editing (LED1 blinks red, LED2 blinks
yellow).
Press
[1] [#] , switch on red LED2 and switch off LED3 by [4] and [6] buttons
pressing. Press [#] (LED1 blinks red, LED 2 -yellow)
Press [2] [#] , switch on red LED2 and off LED3 by [1] , [2] and [3] buttons
pressing.
To switch day/night mode the code/card should have category 2 (twenty-four-hour
access).
Press [4] [#] , switch on LED2 with button [1] pressing, press [#] (red LED1 and
yellow LED2 blink alternately).
Press
[5] [#] , then [2] [#] (red LED1 and yellow LED2 blink alternately).
Next [#] button pressing turns panel to main mode.
Code/card should have category different to 1 one for direct outputs management.
Users' codes review and editing
Press [3] [#] being in code parameters programming mode, then introduce
code [#] or code [#] . The panel reflects user code/card code
with the help of buzzer sounds and LEDs blinking. [#] button pressing returns
the panel to the highest menu level. [*] button pressing allows new user code
introducing. After new code/card introduction panel turns to code parameters
programming.
[#] button pushing returns the panel to the highest menu level.
Programming the panel in stand-alone use