Installation
Attach the i-ALERT
™
Condition Monitor to the pump
CAUTION:
Always wear protective gloves. The pump and condition monitor can be hot.
Tools required:
• 5/32 inch hex wrench
1. Attach the condition monitor (761B) to the bearing frame (228A) using the hex-head screw (372T)
provided.
372T
228A
761B
2. Tighten the hex-head screw with a 5/32 inch hex wrench to 6 ft-lbs (8 Nm).
Installation
14
i-ALERT
™
Condition Monitor Installation, Operation, and Maintenance Manual
Содержание Goulds Pumps i-ALERT
