ITT Goulds Pump 3355, Инструкция по установке, эксплуатации и обслуживанию

Страница: 58 / 79

10. Place the pre-mounted unit on the discharge casing (100D) and tighten the nuts (425) firmly. See
the Torque values table.
11. Rotate the shaft (122) in order to make sure that it turns freely.
12. Mount the coupling half. You might need to preheat to a maximum of 230°F (110°C).
6.7 Assembly references
6.7.1 Torque values
Table 3: Maximum torque values, in ft-lbs (Nm) for 1.5 x 2.5-7 and 2.5 x 4-8 pumps
Thread joint Screw Hexagonal
nut Quality Pump size
1.5 x 2.5-7 2.5 x 4-8
Size Dry Lubricated Size Dry Lubricated
Tie bolt 356S 357F 8.8 3/4-
11UNC 190
(258) 142 (193) 1- 8UNC 325 (441) 295 (400)
Bearing
bracket
(228C) with
suction casing
(100F) or dis-
charge casing
(100D) 356A 425 8.8 8 x M12 31 (42) 28 (38) 8 x M12 42 (57) 38 (52)
Table 4: Maximum torque values, in ft-lbs (Nm) for 4 x 5-10 and 5 x 6-11 pumps
Thread joint Screw Hexagonal
nut Quality Pump size
4 x 5-10 5 x 6-11
Size Dry Lubricated Size Dry Lubricated
Tie bolt 356S 357F 8.8 1- 8UNC 244
(331)
222 (301) 1- 8UNC 352
(477)
320 (434)
Bearing brack-
et (228C) with
suction casing
(100F) or dis-
charge casing
(100D) 356A 425 8.8 8 x M16 71 (96) 64 (87) 8 x M20 112
(152)
99 (134)
6.7.2 Gap widths
Area A - Gap between the sleeve and suction casing
Pump size Nominal diameter Gap "new" (inches) Maximum permissible gap
All iron and stainless fitted Stainless steel
Minimum Maximum Minimum Maximum
1.5 x 2.5-7 1.575 0.004 0.006 0.010 0.012 0.020
2.5 x 4-8 1.850 0.006 0.008 0.012 0.014 0.022
4 x 5-10 2.165 0.006 0.008 0.012 0.014 0.022
5 x 6-11 2.559 0.008 0.010 0.014 0.016 0.024
6.7 Assembly references
56 Model 3355 Installation, Operation, and Maintenance Manual