9.
NOTICE!
Material damage due to overly high pressure when top-
ping up grease
–
When topping up grease avoid overly high pressure.
Top up the hollow spaces of the roller bearings carefully with grease via the
grease nipples, subsequently clean the respective top-up point to remove
any grease leaks.
10.
In the case of drive-side oil lubrication of the bearings, fill the hollow spaces
of the bearings with oil.
Following storage periods exceeding 3 years: ITT Bornemann
GmbH should be contacted in order to put the pump back into oper-
ation.
4.3 Storage
For storage periods longer than 3 months: Observe measures for
long-term preservation (
Chapter 4.2.2 ‘For storage periods longer
than 3 months (maximum 3 years)’ on page 23).
NOTICE!
Property damage due to improper storage!
–
Preserve and store the pump correctly.
1.
Seal off all openings with blank flanges, sealing plugs or plastic covers.
2.
Ensure that the storage site fulfils the following requirements:
n
dry,
n
frost-free,
n
vibration-free.
3.
Rotate the shaft once per month (approx. 30°).
4.
Check the preservation status once per month. Renew the preservation
agent if necessary.
4.4 Removing preservative
Only necessary for preserved pumps.
Transport and storage
Type SLH-4G, SLHS-4G
24
01/2016 JPB Rev. 5
