2
SuperBus® 2000 2 x 20 VFD Alphanumeric Touchpad
Tools Needed
The following must be observed in UL installations
❑
The touchpad hardwire input must not be used for fire
alarm initiating devices.
❑
Only UL-listed devices may be connected to the touch-
pad hardwire input.
❑
The touchpad hardwire input can be configured for
normally closed or normally open protection devices.
❑
For UL installations with UltraGard and Concord (soft-
ware versions 1.0–1.6) panels, do not use the touchpad
hardwire input.
Tools Needed
❑
Drill with bits
❑
Screwdrivers
❑
#6 screws and anchors (included)
❑
Panhead screws for a gang box installation
❑
Saw or utility knife for cutting wallboard
Note
Do not use screws larger than #6 or the touchpad will
not seat properly onto the back-plate.
Installation
The touchpad can be installed on a wall or in a gang box.
To mount the touchpad on a wall:
1.
Separate the mounting bracket from the back-plate by
loosening the two bottom screws and unlatching the
tabs from the mounting slots (see Figure 1).
2.
Place the back-plate on the wall and mark the four
mounting holes and the wire access hole (see Figure 2).
Be sure to leave a 1-inch clearance on all sides of the
back-plate.
3.
Drill holes and insert appropriate anchors.
4.
Secure the back-plate to the wall with included screws.
5.
Cut a hole in the wall where the wire access hole was
marked to pull your cable through.
Figure 1. Touchpad Mounting Slots
To mount the touchpad in a gang box:
1.
Separate the mounting bracket from the back-plate by
loosening the two bottom screws and unlatching the
tabs from the mounting slots (see Figure 1).
2.
Line up the gang box mounting holes with the holes on
the gang box (see Figure 2).
3.
Secure the back-plate to the gang box with panhead
screws.
Note
Do not overtighten screws or the back-plate may bind
and prevent the touchpad from mounting properly.
Figure 2. Back-Plate and Mounting Holes
Wiring
Wiring consists of connecting the touchpad wiring harness
to the panel terminals. You may also connect an optional
hardwire sensor to the touchpad hardwire input wires.
Before You Begin
1.
Disconnect the panel AC power transformer and
backup battery (turn off power switch on UltraGard
panels).
2.
Run a 4-conductor, 22-gauge wire cable from the panel
to the touchpad location.
3.
Splice the 4-conductor cable wires to the matching col-
ored wires located on the touchpad wiring harness.
Find your panel in the next section for specific wiring
instructions.
MOUNTING SLOTS
CABLE OPENING
OPENING FOR CONNECTOR
3101G03B.DSF
LOOSEN BOTTOM SCREWS (X2)
3101G02B.DS4
GANG BOX MOUNTING HOLES (X2)
BACK PLATE MOUNTING TABS (X3)
WALL MOUNTING HOLES (X4)
WIRE
ACCESS
HOLE
