SAW KeyChain Touchpad
Page 1
ITI SAW KeyChain
Touchpad
Document Number: 466-1560 Rev. A
October 1998
Installation
Instructions
Product Summary
The KeyChain Touchpad enables the user to
turn the system on and off after exiting or
before entering the home or to turn on the
siren and to call the central monitoring station
if there is an emergency. If lamp modules have
been installed, the KeyChain Touchpad can be
used to turn all lights using the lamp modules
on or off.
Control Panel Compatibility:
SIMON ™, Con-
cord™
Installation Overview
General Information
The KeyChain Touchpad is an alkaline bat-
tery-powered, wireless touchpad designed to fit
on a keychain, in a pocket or purse. It provides
users a convenient option for the following sys-
tem operations:
Arm the system (doors, windows, and
motion sensors)
Arm the system with no entry delay (if
8348G03A.DS4
60-659-95R
programmed)
Disarm the system
Trigger Panic alarms
Turn system controlled lights on or off
Open the garage door or turn outside lights
on (if programmed)
Installation Guidelines
Use the following guidelines when adding Key-
chain Touchpads to the system:
KeyChain Touchpads are learned into the
Control Panel as sensors or touchpads.
KeyChain Touchpads when programmed
as sensors are programmed as a non-super-
vised sensor.
Each learned KeyChain Touchpad uses
one of the available sensor numbers.
KeyChain Touchpads can be programmed
with no entry delay.
Programming
Follow these instructions to program the
touchpad:
1. Open the control panel cover.
2. Enter Utility Access Code 1 or 2 using the
red-numbered buttons.
3. Press Add from the Start Menu.
4. Press the Sensor/Remote button from the
Main menu and you will hear keychain
remote.
Note: When adding sensors, if you wish to use a more
descriptive location you may press the option button to
use the compass directions (north, north east, east,
south east, south, south west, west, north west).
5. Press DONE.
6. Enter the sensor type number (01, 03, 06,
or 07)
with the red numbered keys
.
Note: If you wish to use a sensor number other than the
next available, enter a 2 digit sensor number with the
red numbered keys immediately after entering the sen-
sor type.
7. Press the lock and unlock buttons simulta-
neously until the transmitter LED is lit.