ITEM C 3-Series, Руководство по эксплуатации продукта

Страница: 65 / 160

Functional safety technology
Page 65
Table 32: Fieldbus-specific assignment of the DIP switches
DIP switch Functionally of the DIP switch (fieldbus specific with technology module)
CAN
(in the basic device)
PROFIBUS EtherCAT
8 Communication:
1: On
0: Off
Communication:
1: On
0: Off Communication:
1: On
0: Off
1)
7 Baudrate:
11: 1 MBaud
10: 500 kBaud
01: 250 KBaud
00: 125 kBaud Slave address respectively
address offset
2)
:
0 .. 127
valid range:
3 .. 125
No function
1)
6
5 Node address respectively
address offset
2)
:
1 ... 31
4
3
2
1
1
If all DIP switches == 0: automatic start-up of EtherCAT is activated

EtherCAT is switched on.
If at least one of the DIP switches 1 to 7 <> 0 and DIP switch 8 == 0: no automatic start-up of EtherCAT

EtherCAT is switched off.
2)
If necessary, the addresses will be added as an offset of a predefined base address of the corresponding bus system. The base address
can be predefined in the
item Motion Soft®
and can then be saved in the parameter set of the
item C Series
.
The activation of a fieldbus via the DIP switch takes precedence over the activation of the fieldbus based on the parameter
data set.
In order to be nonetheless able to change settings and test different configurations during the operation, the fieldbus menu of
the item Motion Soft
®
can be used.
After a reset, however, the setting of the DIP switches will be checked and used.
Example:

DIP switch position <> 0 and DIP8 = ON

fieldbus always activated, can be changed via item Motion Soft
®
.

DIP switch position <> 0 and DIP8 = OFF

fieldbus always off, can be changed via item Motion Soft
®
.

DIP switch position = 0

fieldbus configuration based on the parameter set. Can be changed and saved via
item Motion Soft
®
(downward-compatible).