![background image](http://html1.mh-extra.com/html/item/c-3-series/c-3-series_product-manual_2095511118.webp)
Service functions and error messages
Page 118
11.1.8
Power monitoring of the brake chopper
The firmware includes an "I²t brake chopper" power monitoring system for the internal braking resistor.
When the "I²t brake chopper" power monitoring value reaches 100%, the power of the internal braking resistor will be reduced
to nominal power.
11.1.9
Start-up status
Servo positioning controllers, which are sent to item for service, will be equipped with a different firmware and different
parameters for testing purposes.
Before the end user uses the item Servo Positioning Controller C 3-Series once again, it must be parameterised. The item
Motion Soft
parameterisation software checks the start-up status and requests the user to parameterise the servo positioning
controller. At the same time, the device displays an "A" on the seven-segment display to indicate that it is ready but not
parameterised.
11.1.10
Rapid discharge of the DC bus circuit
If the system detects a failure of the mains power supply, the DC bus circuit will be rapidly discharged within the safety period
in accordance with EN 60204-1.
Delayed activation of the brake chopper based on power classes in the case of parallel operation and mains power supply
failure ensures that the main energy during the rapid discharge of the DC bus circuit is taken over by the braking resistors of
the higher power classes.
11.1.11
Operating hours counter
The implemented operating hours counter is rated for a minimum of 200,000 hours of operation. The operating hours counter
is displayed in the item Motion Soft
parameterisation software.
Содержание C 3-Series
Страница 12: ...Page 12 Figure 33 Servo positioning controller with an integrated technology module 160 ...
Страница 70: ...Mechanical installation Page 70 Figure 8 item Servo Positioning Controller C 3 Series installation space ...
Страница 71: ...Mechanical installation Page 71 7 2 Device view Figure 9 item Servo Positioning Controller C 3 10 front view ...
Страница 76: ...Electrical installation Page 76 Figure 14 Complete set up of the item C 3 Series with a motor and PC ...