Initial operation
Page 109
10.4
Connecting the item servo positioning controller C 1-Series to the
power supply
Make sure that the power supply has been switched off
Plug the PHOENIX connector into socket [X9] of the servo positioning controller
Connect the PE line of the mains to the PE socket
Connect the 24 V connections to a suitable power supply unit
Make mains supply connections
Check all connections again
10.5
Connecting the PC (serial interface)
Plug the D-Sub connector of the serial interface cable into the socket for the serial interface of the PC and fasten the bolting
screws
Plug the D-Sub connector of the serial interface cable into the socket [X5] RS232/COM of the item servo positioning controller
C 1-Series and fasten the bolting screws
Check all connections again
10.6
Connecting the PC (USB interface, alternative)
Plug the plug A of the USB interface cable into the socket for the USB interface of the PC
Plug the plug A of the USB interface cable into the socket [X19] USB of the item servo positioning controller C 1-Series
Check all of the plug-and-socket connections once more
10.7
Checking operability
Make sure the controller enabling switch is turned off
Switch on the power supply of all devices. The READY / ERROR LED on the front of the servo positioning controller should now
be active green
If the READY LED does not light green but red, there is a malfunction. If the seven-segment display indicates a number
sequence, it is displaying an error message. You have to take care of the corresponding problem. In this case please continue
with
chapter 11.2.2 Error messages (page 114).
If the device displays nothing, follow these steps:
Switch off the power supply
Wait 5 minutes, so the DC bus can discharge
Check all connection cables
Check the functionality of the 24 V power supply
Switch the power supply back on