item Controller BL 1-04 /C
― Product manual
38
8.4 Resolver connector [X2A]
Characteristic
Value
Transformation ratio
1:2 to 1:4
Carrier frequency
5-10 kHz
Excitation voltage
5-6 Veff, short-circuit-proof
Excitation impedance (at 10 kHz)
4 Ω
Stator impedance
> 30 Ω
Measuring range (for Hall sensors)
7 V
ss
Resolution
14 bits
Signal detection delay
< 200 µs
Speed resolution
approx. 5 rpm
Actual speed value filter
400 µs
Absolute angle detection accuracy
< 0,022°
Max. speed
16.000 rpm
8.5 Encoder connector [X2B]
INFO
Possibly not all encoders of a manufacturer are supported
It is possible that not all encoders of a manufacturer are fully supported. In individual cases it is therefore always recommend
-
ed to test the encoder in advance in the intended application.
Power supply output
The power supply for the encoders can be changed.
NOTICE
Risk of destruction due to excessive voltage
If the voltage is too high, the angle encoder may be destroyed. Ensure that you have selected the correct supply voltage prior
to connecting the encoder to the [X2B] connector.
Characteristic
Value A
Value B
Output voltage
5,4 V
10,4 V
Output current
250 mA
200 mA
Short-circuit strength
Yes
Yes
Control via sense leads
Yes
Yes
