31
item Controller BL 1-04 /C
― Product manual
6 Storage/transport
The following requirements must be fulfilled for the storage and transport of the servo drive:
Storage
▪ Store the servo drive in line with the specified storage temperatures. Use only its original packaging.
▪ After approximately six months of storage, the oxide layer of the capacitors may become damaged. This is why the servo
drive must be supplied with power for approximately 1 hour every six months (24 V and 230 V) in order to preserve the
oxide layer.
Transport
CAUTION
Risk of injury due to improper transport
Follow these instructions to ensure the safe transport of the servo drive and to avoid injuries.
▪ Use only qualified personnel for the transport of the servo drive.
▪ Transport the servo drive only in its original packaging.
▪ Use only suitable transport equipment.
▪ Use suitable personal protective equipment.
▪ If you notice that the packaging is damaged, notify the carrier without delay. Then, inspect the servo drive for any signs of
external or internal damage.
Transport damage
DANGER
Dangerous electrical voltage!
Transport damage to the servo drive may compromise the insulation between the low- voltage part and the high-voltage part.
This results in an extremely dangerous electrical voltage.
Do not use the servo drive in this case. The servo drive needs to be checked by the sales partner or manufacturer.
In case of external damage (dents, deformed mounting flange, etc.) it must be presumed that some of the components have
come loose and the breakdown strength concerning the high-voltage part may no longer be existent.