8
www.itec-audio.com
MICROPHONES
ITEC RADIO MICROPHONE SYSTEMS
3.2.
Beltback transmitter
ITEC WT-716-A
Battery indicator:
The red / green battery status indicator indicates the battery condition: when turned on, the indicator lights
red for about 1 second and then turns green. If it is constantly red, this is a warning that indicates the weak
state of the batteries.
Changing the batteries:
Open hinged lid, press the two snapper left and
right at the same time. Always both batteries are to be replaced.
Be careful when inserting the batteries (see picture, insert batteries with
the negative pole at the spring contact).
Battery type: 2 pcs. „AA“ (Mignon), 1.5V.
Annotation:
Old batteries are hazardous waste and must be disposed of accordingly.
Some batteries (especially low-priced products) may leak if stored for a long time, leading to corrosion and
destruction of the battery contacts and the PCB. Use high quality alkaline batteries, these also allow a longer
operating time.
Regargeable Batteries:
Alternatively, the wireless microphone WM-716-A can also be operated with two pieces of NiMh regargeable
batteries of size „AA“. Use the original charging station HC-92 for charging.
Never insert with a microphone with a battery into the charging station.
Frequency adjustment:
Open hinged lid and turn the rotary switch to the desired
channel with a small screwdriver (see point 5, frequency list).
Adjust with the transmitter switched off or after setting, switch
the transmitter on / off again, so that new selection is accepted.
Furthermore, there are two controls in this area for adjusting the
volume of different microphones. If you get transmitter and
microphone from ITEC, an optimal setting has already been made.
Therefore, make changes to these controllers only in exceptional cases.
„MT“ adjusts the level of a microphone and „GT“ that of a guitar or a transmission cable.
ith
ith
gly.
Battery status indicator
