MULTIMIX 8/4 DIGITAL
www.itec-audio.com
MULTIMIX 8/4 DIGITAL
5) Fix the DSP module with three screws
6) Reinsert the top and bottom cover
B) Software settings
1) Connect the Multimix 8/4 digital with a computer and make sure the device is switched on.
2) Run MixDesign (At least Version 2.0)
Go to “
Extras
”|”
Hardware setup
” and click menu item "
DSP is installed
"
After the device has restarted itself automatically, the DSP related settings are available.
Note: If the item is disabled, go to “Extras”|”MixDesign preferences” and check the item
"Enable hardware setup changes" in "Other options"
Removing the DSP Module
A) Hardware removal
1) Remove the top and bottom cover of the device (8 screws for each side)
2) Remove the DSP module
3) Insert 4 jumpers of the DSP section (marked “3”,”4”,”1”,”2”)
4) Reinsert the top and bottom cover
B) Software settings
1) Connect the Multimix 8/4 digital with a computer and make sure the device is switched on.
2) Run MixDesign (At least Version 2.0)
On connecting, a message box will pop up to inform you that the DSP doesn´t answer.
Go to “
Extras
”|”
Hardware setup
” and click menu item "
DSP is not installed
"
17
