ITC IJS2000, Руководство оператора

Страница: 3 / 21

3
FRANÇAIS
ENGLISH
13. MAINTAIN TOOLS WITH CARE. Keep tools sharp and clean for better and safer
performance. Follow instructions for lubricating and safe performance. Follow
instructions for lubricating and changing accessories. Keep handles dry, clean
and free from oil and grease.
14. ALWAYS CHECK AND MAKE SURE TO REMOVE ANY ADJUSTING KEYS
OR WRENCHES from the tool or work surface before turning the tool on. Left
attached, these parts can fly off a rotating part and result in personal injury.
15. AVOID UNINTENTIONAL STARTING. Be sure the switch is in the OFF position
before plugging in.
16. DO NOT USE THE TOOL IF IT CANNOT BE SWITCHED ON OR OFF. Have
your tool repaired before using it.
17. DISCONNNECT THE PLUG FROM POWER BEFORE MAKING ANY ADJUST-
MENTS. Changing attachments or accessories can be dangerous if the tool
could accidentally start.
18. STAY ALERT. Watch what you are doing & use common sense. Don’t operate
any tool when you are tired.
19. CHECK FOR DAMAGED PARTS. Before using this tool, any part that is dam -
aged should be carefully checked to determine that it will operate properly and
perform its intended function. Check for alignment of moving parts, binding of
moving parts, breakage of parts, mountings, and other conditions that may affect
its operation. Inspect screws and tighten any that are loose. Any part that is dam -
aged should be properly repaired or replaced by an authorized service center
unless otherwise indicated elsewhere in the instruction manual. Have defective
switches replaced by an authorized service center. Don’t use the tool if switch
does not turn it on and off properly.
20. REPLACEMENT PARTS. When servicing, use only identical replacement parts.
21. SERVICE AND REPAIRS should be made by qualified repair technicians at an
authorized repair centre. Improperly repaired tools could cause serious shock or
injury
22. EMPLOYER MUST ENFORCE COMPLIANCE with the safety warnings and all
other instructions contained in this manual.
23. KEEP THIS MANUAL AVAILABLE for use by all people assigned to use this
tool.
SPECIFIC SAFETY INSTRUCTIONS
WARNING! Risk of Explosive Gases
1. WORKING NEAR A LEAD-ACID BATTERY IS DANGEROUS. Batteries gener-
ate explosive gases during normal operation. Do not face the battery during
connection and stay as far as possible away from the battery being charged.
2. READ AND FOLLOW THE INSTRUCTIONS IN THIS MANUAL AND THOSE
FOR THE VEHICLE’S BATTERY AND ELECTRICAL SYSTEM. Review all
caution markings on these products and on the engine.
3. WEAR EYE PROTECTION AND PROTECTIVE CLOTHING.
4. HAVE PLENTY OF FRESH WATER AND SOAP AT HAND in case battery acid
contacts skin, clothing, or eyes. Avoid touching eyes while working near battery.
If battery acid contacts skin or clothing, wash immediately with soap and water.
If acid enters the eye(s), immediately flood with cold water for at least 10 minutes
and get medical attention as soon as possible.
5. DO NOT SMOKE NOR ALLOW SPARKS NOR FLAME in the vicinity.
6. BE CAUTIOUS WITH METAL TOOLS contacting the vehicle battery. Do not
drop metal tools onto the battery. Contact between metal and the positive bat -
tery post may cause a spark, or short-circuit the vehicle battery or some other
electrical component, which in turn may cause electrical system damage or an
explosion.
7. REMOVE METAL PERSONAL ITEMS such as rings, bracelets, chains, or pen-
dants when working near a lead-acid battery. Contact between a metal item and
the positive post on the vehicle can produce a short circuit current high enough
to cause a severe burn.
IMPORTANT SAFETY INSTRUCTIONS
SPECIFIC SAFETY INSTRUCTIONS FOR JUMPSTART
!