3030 Corporate Grove Dr. • Hudsonville • MI • 49426
Phone: 616-396-1355 • www.itc-us.com • [email protected] • DOC#: 710-00026 Rev C • 09/13/17
VersiControl RGB Control Pad Install Instructions
(Part #’s: 21055)
Safety Instructions
• Disconnect power before installing, adding or changing any component.
• To avoid a hazard to children, account for all parts and destroy all packing materials.
• Do not install any luminaire assembly closer than 6” from any combustible materials.
• Positive (+) outputs require a fuse if the attached wire leads are not rated to handle the max current.
For warranty information please visit www.itc-us.com
1.
INSTALL CONTROL PAD:
Determine the installation location of your control pad. Note the control module comes with a 7” long cord so
the control pad will need to be located near the module. Drill a 2” hole and insert the control pad. Install the mounting bracket using the
two 3x19mm stainless steel Phillips pan head screws provided. Do not fully torque screws until both have been partially installed.
PARTS / TOOLS NEEDED:
VersiControl RGB
Smart Pad
RGB Lighting
(Varies)
Mounting Screws x 2
2” Hole Saw Bit
Power Drill
2.
CONNECT CONTROL PAD:
Insert the connector on the control pad into the
connector on the module.
Controller
1
5
4
3
2
6
V(+)
V(-)
Shield
Signal Line
CAN (+)
CAN (-)
*Mating connector Deutsch DTM06-6S
