502.601 Hydraulic Punch Instructions
Operating Instructions
1.
Several parts will be needed to complete the punching process.
Use the chart below to select the correct punch, die, draw stud
and spacers.
2.
Drill an 11mm wide leading hole through the steel plate at the
desired punch point.
3.
Screw the ¾” draw stud into the puncher head. Put
the appropriate space and female die into place.
Note: if using the 3/8” draw stud, then both draw
studs and all three spaces must be used together.
4.
Insert the draw stud through the lead hole. Screw the
male die end of the draw stud until the steel plate is
secure between both dies. (see illustration)
5.
Open the release valve on the pump by turning the knob
counter-clockwise. Connect the pump hose to the puncher
and secure the couplers firmly.
Punch
Dies
Ø hole
(mm)
Step 1
Step 2
Primary Perforation
Draw Stud
Spacer
Drill
Punch
Setting Thread
L
M
S
1/2"
21.8
Ø 11mm
3/8”
3/4"
27.3
1/2"
3/8”
3/4”
-
-
1”
34.1
1–1 1/4"
42.7
1–1 1/2”
48.7
2”
60.5
1
