![Italjet Dragster 2022 Скачать руководство пользователя страница 48](http://html1.mh-extra.com/html/italjet/dragster-2022/dragster-2022_maintenance-manual_2094790048.webp)
Exhaust system
The exhaust system includes catalytic converters to
reduce harmful exhaust emissions.
Warning
The exhaust system temperature rises after the
motorcycle runs. To prevent the risk of fires or
burns:
- Do not park near materials that may pose a fire
hazard, such as grass or other flammable
materials.
- Park the vehicle out of the reach of pedestrians or
children of hazards of thermal exhaust system
- Check that the exhaust system is cooled before
maintenance.
- Never run the engine without driving the motorcycle,
even for a few minutes. Idling for long periods of time
may cause heat buildup.
Accessory parts and USB socket
Warning
Do not connect accessories to the USB socket after
the engine is turned off, and the load should not
exceed 12 watts (1 amp), otherwise the fuse will be
blown and the battery cannot be charged.
Use the USB socket
- Open the dust cover
(
1
)。
- Connect the accessories to the socket
(
2
)。
- Put the dust cover back properly when the socket is
not in use.
48
Содержание Dragster 2022
