iSystem IOM6 CAN/LIN, Руководство пользователя

Страница: 14 / 20

CAN cable banana jacks & pin wires
The DB9 connector with the termination switch must be connected to the IOM6 CAN/LIN
Accessory (CAN1 or CAN2).
CAN cable banana jack
Ordering code IC57040-CAN-JACK
The IC57040-CAN-JACK is used to connect the IOM6 CAN/LIN Accessory to an existing CAN
network through the banana jacks. The 120 Ohm termination impedance is selected using the
switch located on the cable DB9 connector. Cable length is 0.65m.
Cable and pin color Signal
BLACK CAN_GND
YELLOW CAN_H
GREEN CAN_L
CAN cable pin wires
Ordering code IC57040-CAN-PIN
The IC57040-CAN-PIN is used to connect the IOM6 CAN/LIN Accessory to an existing CAN
network to the pins typically found on a 2.54mm pitch header (0.63mm square pins). The 120
Ohm termination impedance is selected using the switch located on the cable DB9 connector.
Cable length is 0.65m.
Cable and pin color Signal
BLACK CAN
YELLOW CAN_H
GREEN CAN_L