iSystem IC57163, Руководство пользователя

Страница: 9 / 24

Device description
A – 10-pin DAP connector, with the following pinout:
Signal
Direction
Signal
Description
Signal Pin Pin Signal
Signal
Description
Signal
Direction
I
Reference
Voltage
Vref 1 2 DAP1 DAP Data I/O
Ground GND 3 4 DAP0 DAP Clock O
Ground GND 5 6 DAP2
Optional 2nd
Data Pin
I/O
Not Connected NC 7 8 nTRST/DAPEN Optional 3rd
Data Pin
I/O
Ground GND 9 10 nRESET Reset O
10-pin DAP pinout
B – 10-pin DAPE connector, with the following pinout:
Signal
Direction
Signal
Description
Signal Pin Pin Signal
Signal
Description
Signal
Direction
I
Reference
Voltage
Vref 1 2 DAPE1 DAP Data I/O
Ground GND 3 4 DAPE0 DAP Clock O
Ground GND 5 6 DAPE2
Optional 2nd
Data Pin
I/O
Not Connected NC 7 8 DAPEN/DAP3
Optional 3rd
Data Pin
I/O
Ground GND 9 10 NC Not Connected
10-pin DAPE pinout
Signal direction definition:
O – Output from the Active Probe to the target microcontroller
I – Input to the Active Probe from the target microcontroller
C – FNet Micro connector, that connects the Active Probe to the iC5700 BlueBox. The FNet
Micro cable is delivered with the Active Probe.
D – The indicator light provides the status of the Active Probe as follows:
·
Permanently green - Powered On and ready
to use
·
Blinking green – Establishing connection
with the Blue Box
·
Blinking blue – Reprogramming SPLASH
·
Permanently magenta – Golden image
loaded and ready to use
When powering on the system, switch the iC5700 on before powering on the target
system. When powering down the system, power off the target before powering off the
iC5700!
Use only original iSYSTEM accessories for powering and connecting with the iC5700.
Consult with iSYSTEM before attempting to use any other accessory.