SAFETY RULES
SAFETY RULES
APPLICABLE RULES OF A GENERAL NATURE
D A N G E R
»
Before any repair or maintenance work on the jet wash or any of its optional extras,
disconnect the main power switch or the corresponding device, and work without current
or compressed air.
»
Where your jet wash has a lance with no trigger, take extreme care when activating the
program because the lance will start shooting water automatically after the countdown.
»
Removal of safety devices and unauthorized modification of the equipment will automatically
render the guarantee null and absolve the manufacturer of any responsibility.
»
Take special care to avoid slipping when the bay is wet. The wash bay surface shall be
non-slip.
»
Should the user, facility or maintenance supervisor or any person belonging to the
organisation observe any situation of danger or potential danger either to persons or to the
jet wash, they shall stop the machine immediately. The jet wash should work properly as
long as the ambient temperature stays between 1 and 45ºC.
»
Do not under any circumstances point the lance or pistol directly at anyone, even when the
machine is out of service, has no credits, etc.
»
Do not insert credits if the lance or pistol is not in its holder.
D A N G E R
»
Do not under any circumstances open an electricity box not provided with a power switch.
WA R N I N G
»
Install the unit in a suitably ventilated area, and protected against freezing.
»
The main power must always be ON. Switch off only when there is a fault or for maintenance.
»
Tyres can be damaged if the distance from the nozzle to the tyre is under 20 centimetres;
or if any one part of the tyre is subjected to a high pressure spray for more than 5 seconds;
or when spraying directly where the rim meets the tyre.
»
Use of rotating and zero angle nozzles is not recommended.
7
