Page 26 of 48
Heatpipe Furnace Models 17702W, 17702P, 17702S (13
–
07/20)
This PROGRAM has 7 segments.
It shows the furnace instrument starting with a setpoint of 0.00°C
•
It is then set to RAMP to 150°C over a period of 120 minutes
•
It is then set to DWELL at this temperature for a period of 120 minutes
•
It is then set to RAMP to 300°C over a period of 120 minutes
•
It is then set to DWELL at this temperature for a period of 120 minutes
•
It is then set to RAMP to 450°C over a period of 120 minutes
•
It is then set to DWELL at this temperature for a period of 120 minutes
•
It is then set to END and RESET to 0.00°C
To enable/RUN this PROGRAM:
1.
Log in as the SUPERVISOR and exit menu
2.
Scroll to the PROGRAM page
3.
Press the SCROLL button to highlight the RESET box
4.
Press the UP button to highlight the PAGE icon in the top right-hand side of the screen
5.
Enter this with the SCROLL button
6.
This will access the PROGRAM EDIT menu page
7.
Scroll to OPERATION and select LOAD, enter with the SCROLL button
8.
Scroll to TEST_1 and enter with the SCROLL button
9.
The STATUS will display SUCCESS and the CURRENT PROGRAM will display TEST_1
10.
TEST_1 is now the default program
11.
To RUN the program TEST_1 exit the PROGRAM EDIT page using the PAGE button until you see
the PROGRAM homepage
12.
Press SCROLL once to highlight the RESET box
13.
Scroll to TEST_1 and press the SCROLL button to initiate the program
The page will now change to show the current program running.
To edit an existing PROGRAM:
1.
Follow the above procedure to point 10
2.
Scroll down to SEGMENT NUMBER and select the SEGMENT you wish to edit using the SCROLL
and UP/DOWN buttons
3.
Edit the required parameter (RAMP, DWELL, TIME DURATION etc) using the scroll and UP/DOWN
buttons and enter the value
4.
When the editing is complete, it can either be left as the existing PROGRAM or saved under an
alternative file name in the internal memory
5.
To leave the alterations under the existing filename simply exit out of the menu and RUN the
program as normal
6.
To save as an alternative filename in the memory, SCROLL back up to OPERATION and enter
using the SCROLL button
7.
Scroll to STORE and enter
8.
The soft keyboard will open allowing you to save the file as a filename of your choice
9.
When the name is selected, press the PAGE button to save the changes
10.
Both the original file and the modified file will now exist in the memory
