ISOLITE
WWW.ISOLITE.COM
ISOLITE HEADQUARTERS
800.888.5483
31 WATERLOO AVENUE BERWYN, PA 19312
ISOLITE WEST
800.799.5343
3563 SUELDO SUITE M, SAN LUIS OBISPO, CA 93401
BAL1400TD
P.1
INSTALLATION GUIDES ARE SUBJECT TO CHANGE WITHOUT NOTIFICATION.
CONTACT ISOLITE FOR UP TO DATE DETAILS.
WHEN USING THIS LIGHTING DEVICE, SAFETY PRECAUTIONS SHOULD BE FOLLOWED AT ALL TIMES
READ THE INSTRUCTIONS BELOW CAREFULLY AND FOLLOW THEM FOR YOUR OWN SAFETY!
PLEASE SAVE THESE INSTRUCTIONS.
BAL1400TD
INSTALLATION INSTRUCTIONS
FLUORESCENT EMERGENCY BALLAST
1400 LUMENS (TIME DELAY)
1.
Prior to installation, battery connector must be left open to prevent high voltage from
being present on output leads (red & yellow). It must be connected only after installation
is complete and A.C. Power is supplied to the unit.
2.
This unit can operate commonly used linear and compact fluorescent lamps. Please refer
to the “lamps list” label on the ballast for specific lamp information.
3.
Please ensure the electricity connections conform to the National Electrical Code and local
regulations if applicable.
4.
To avoid electric shock, please disconnect normal and emergency power supplies, and
battery connector of the emergency ballast before servicing.
5.
This device is designed for factory or field installation in either the ballast channel, or
on top of the fixture, except air handling heated air outlets, wet or hazardous location
fixtures. Do not install this device near gas or electric heaters.
6.
AC power source of 120 VAC or 277 VAC is required.
7.
The battery in this unit is sealed, and not replaceable in the field. Please contact
manufacturer for information on servicing the battery.
8.
Do not use accessory equipment that is not recommended by manufacturer. Failure to do
so may cause unsafe conditions. Servicing should only be performed by qualified service
personnel.
9.
Do not use the product for other than it s intended purpose.
CAUTION: Verify that all replacement lamp types marked on the installed luminaire are also
identified as suitable for use with this inverter/charger pack.
