The manuf
actur
er guar
antees only Engl
ish text a
vailable on our web si
te www
.isoil.com
MAN_MV110_EN_IT_IS_R13_1.04.XXXX
43 / 89
MENU 2 - UNITS
Sensor diameter unit of measure (mm or inch)
Sensor cable length for separate version. Select m or foot.
Flow rate type unit of measure. Select metric or not metric (Imperial units)
This function is active with POS. 1.7 see page 34 enable.
This function changes the choice of unit of measure POS. 3.3 see page 34
Pulse 1 type unit of measure: metric or not metric (Imperial units).
This function is active with POS. 7.2 see page 35 enable.
This function changes the choice of unit of measure POS. 3.5 see page 34
Pulse 2 type unit of measure: metric or not metric Imperial units).
Setting total direct totalizer unit of measure type: metric or not metric Imperial units.
This function changes the values unit of measure on POS. 2.7 see page 33
Setting total direct totalizer unit of measure.
This function is visualized on visualization pages.
WARNING:
The totalizer value is updated and changed depending on the setting of unit value.
The scale change may cause accuracy loss depending of rounding up.
For example, if T +=0,234 liters with 3 decimals, it become T +=0.001 m³ losing 0.234 liters in rounding up.
(POS. 2.1)
Sensor DIameter Unit of Measure
[Diam.= mm]
AL2
[SDIUM]
(POS. 2.3)
Flow Rate Unit of Measure Type
[FR unit= METRIC]
AL2
[FRMUT]
(POS. 2.4)
PuLse 1 Unit of measure Type
[PL1 unit= METRIC]
AL2
[PL1UT]
(POS. 2.5)
PuLse 2 Unit of measure Type
[PL2 unit= METRIC]
AL2
[PL2UT]
(POS. 2.6)
Totalizer Total Positive Unit of measure Type
[U.m. T+ = METRIC]
AL2
[TTPUT]
(POS. 2.7)
Totalizer Total Positive Unit of Measure
[U.m. T+= m³]
AL2
[TTPUM]
(POS. 2.8)
Totalizer Partial Positive Unit of measure Type
[U.m. P+= METRIC]
AL2
[TPPUT]
(POS. 2.9)
Totalizer Partial Positive Unit of Measure
[U.m. P+= m³]
AL2
[TPPUM]
(POS. 2.8)
Totalizer Total Positive Decimal Point position
[N.d.T+= METRIC]
AL2
[TTPDP]
(POS. 2.2) Sensor CAble LeNgth
[S.cable= m]
AL2
[SCAUM]
Setting total direct totalizer decimal point position.
Example: P+D.P.= 3 visualized value P+ dm³ 0.000 / P+D.P.= 2 visualized value P+dm³ 0.00
Setting partiall direct totalizer unit of measure type: metric or not metric Imperial units.
This function changes the values unit of measure on POS. 2.7 see page 33
Setting partial direct totalizer unit of measure.
This function is visualized on visualization pages.
