iSocket
®
GSM 706/707
www.isocket.eu
© Copyright Intellectronics 2012
All rights reserved. Version 1.1.2-EN
- 22 -
English
and/or restored. This number is also used for other notifications. You can only disable
this feature by removing the number for notification.
Note!
This feature might be unstable if you use more than one ALERTNUMBER. On the
"707" model, the unit might sometimes remain turned on after you have disconnected it
from the power source. This is because of the built-in battery. If this happens please
remove the sim card from the unit and wait for a while. It will switch off after a
maximum of 6 minutes.
13. Credit Information and Subscription Management
(experimental)
You can get SIM-card credit information. Not all operators provide such service. With
prepaid cards this service is usually available. For the monthly mobile subscriptions it is
not available. You can also activate some UMS codes remotely. Please see additional
information on the use of these features on our website
www.isocket.eu
.
Command
Description
Response
Type
SALDO
Information about balance (SALDOUMS must
be pre-installed)
Response from mobile
operator
Ctrl
SIMCARD*X#
To manage your subscription by UMS codes
Response from operator
30min
SALDOUMS=*X#
To install UMS code for balance check. For ex.,
SALDOUMS=*100#. Ask UMS code from your
mobile operator
SALDOUMS=*100# - OK
30min
SALDOUMS=NO
Remove UMS code for balance from memory
SALDOUMS=NO - OK
30min
SALDOUMS?
Information about SALDOUMS settings
SALDOUMS: *100#
Inf
14. Version Information
Command
Description
Response
Type
HARDWARE
Reports the name of the product and the
version of the hardware
iSocket GSM 706, Hardware
v1.1
Ctrl
SERIALNUM
Reports the serial number of the device
S/N: 12345678987654321
Ctrl
FIRMWARE
Reports the version of the firmware
(c) Intellectronics, v1.0.0
Ctrl
15. Original Factory Settings
Each new device has pre-configured factory settings. These are the so-called default
values. These settings are described in the table below. The device can be returned back
to these default values at any time. The reset button is positioned on the front panel
next to the logo (see Chapter 1). To reset the device, press this button with a suitable
thin object, hold it for 5 seconds and then release. When you release the button, all
indicators (except GSM) should start blinking for next 10 seconds.
Please press the button again within these 10 seconds to confirm reset to
factory defaults.
Then wait until the device reboots. Your device is now returned to the
original factory configuration.
NOTE!
Correct operation of these experimental features cannot be guaranteed. We
reserve the right to remove these features in future versions of devices. The absence or
incorrect function of these features on your device will not be covered by warranty. The
ISGSM707xx models do not come with this feature.
NOTE!
All your personal settings will be erased during this reset procedure
Содержание GSM 706
Страница 1: ......
