iSMA-B-FCU Hardware User Manual
www.ismacontrolli.com
DMP242en | 1st Issue rev. 3 | 02/2022
page 18 of 53
4.7 Default Settings
Out of the box device as well as after restoring default values procedure, has got the
following default settings:
Name
Default Value
User baud rate
76800
Stop bits
1
Data bits
8
Parity bits
0
Response delay
0
I1-I4 digital input counters
0
Table 8. Default values
4.7.1 Restoring Default Settings
To restore the default iSMA-B-FCU device settings, follow the steps below:
Step 1:
Turn power supply off
Step 2:
Set section 6 of Protocol switch to ON
Step 3:
Turn on power supply, power LED blinking
Step 4:
Switch section 6 of Protocol switch to OFF to restore the default settings. To
cancel the reset, turn off the power and switch section 6 of Protocol switch to the OFF
position.
