6-6
Trouble Shooting
Chapter 6
Proceeding
1.
Recorder is switched on.
Press
R
and
E
and keep pressed.
Press
S
. Keep all 3 keys for 1 sec. until the
beginning of the reset is displayed.
2.
Start reset with
E
.
.
Reset can be interrupted with
R
and
S
.
3.
During the reset is executed all centre lines
flash.
After reset has been finished, the recorder switches to normal operation. Current
date is displayed. The saved parameters can be loaded back into the recorder.
Hardware test
The recorder is provided with special test routines to check different hardware
modules and the function of them.
Display-, printer- and memory test
The test mode of the recorder is activated if the recorder is switched on and the key
"E" is pressed simultaneously until the adjustment routine has finished. In this test
mode the display, the printer and all the memories are checked.
When the test routine is started all the display elements are flashing. The card lift is
set automatically for the print out of the test report. The test routine can be
interrupted by pressing any key and is started as soon as a time card is inserted into
the recorder.
In the printer test the word "DRUCKERTEST" and the numbers "0123456789" in the
formats narrow, normal, double and bold are printed on the time card. To check the
horizontal print position, 15 crosses are printed three times in the same line.
Now all the memories are checked. All the test results are printed on the time card.
Finally the test for the serial interface is performed. Therefore you have to connect
the transmission conduction with the receiver conduction via the line adapter.
