ICV 4030 - CNC-Compact-Machine with CAN Controller
Page - 10
When the hood is open, protection from moving parts of the
machine is not guaranteed any more !
Therefore the key should only be used by authorized experts !
6.2 First startup
At the first startup, please conduct following steps:
-
To open the hood for the first time plug in the line cord and turn on the master switch.
The COVER button should be highlighted. Only with that button highlighted will it be
possible to open the hood.
-
For all following functions the emergency stop has to be unlocked.
-
Close the hood and turn on the power amplifiers by pressing the POWER button. The
button has to be highlighted.
-
You can call the software any time. An error message will appear if the machine is not
ready for operation (power amplifiers not turned on).
-
The hood is locked during the machining process. It can only be opened when the
machine stands still, the machine tool is turned off and the software allows the hood to
be opend (COVER button is highlighted).
-
To open the hood you have to press the COVER button. After closing the hood it will be
locked automatically. To start the machine, press again the START button.
Please refer to the software manual for all further information regarding the working with the
software.
Key-operated switch
If you want to check the program, the hood can be opened during operation when you
switch the key-operated switch to TEST (test mode). For this the machine tool must be
turned off, the program, however, will continue.
Make sure the tool is disengaged from the workpiece!
Machine tool
The machine tool is directly wired and controlled by the software. As well are the three
other, optional switching outputs, which can be used to control additional devices (refer to
technical data). The machine tool can be turned on only when the POWER button is
highlighted, the hood is closed and locked, the rotary switch is ON and the software is
controlling the machine.
