Iseki SXG216, Руководство по эксплуатации

Страница: 50 / 94

VIII. MAINTENANCE
49
CAUTION: When any abnormality is found
with the steering wheel or toe-in of the
tyres, ask your dealer to correct it, because
the correction of the steering system re-
quires special tools and special training.
17. ENGINE OIL REPLACEMENT
IMPORTANT: • The engine oil should be replaced with
fresh oil in accordance with operation
hours. If not, overly used oil will cause
engine troubles.
• The first replacement should be done
after the initial 50 hours of operation and
then after every 100 hours of operation.
When replacing engine oil, place the
lawn mower on level, hard ground. The
engine oil drain is located on the bottom
of the engine oil pan, which is accessi-
ble from the left side of the lawn mower.
a. Place a tray or the like under the oil drain to receive
drained oil.
b. The engine should be warmed up for 10 minutes or
so ahead of time to heat the oil to lower its viscosity
for complete drainage.
(1) Oil pan (2) Drain plug
c. Remove the drain plug allowing the used oil drain
out completely.
d. When the used oil has drained out completely,
screw the drain plug back in securely.
e. Remove the oil filler cap from top of the cylinder
head and pour in fresh engine oil through the oil
filler. Be sure to use recommended oil by ISEKI.
Refer to “ENGINE OIL LEVEL” on page 41.
1
2
(1) Engine (2) Filler cap
Engine oil capacity: 2.2 liters (0.48 imp.gal.)
f. After engine oil replacement, start the engine and
let it idle for a while.
g. Then stop it and wait for a while until the engine
oil comes down into the oil pan. Now check the oil
level to check if it is at the upper limit or not. When
the level is low, replenish until the level reaches the
upper limit.
IMPORTANT: Never fill over the upper limit, or it
may cause engine trouble.
h. Make sure that there is no oil leakage through the
drain plug and oil filter.
Engine oil cap should
be removed by pulling
it up to upper direction.