HARDWARE TYPES
Device
Standalone High Voltage Power Supply
Crate
Case / Bin for a modular HV-supply (module), which supplies power
Controller
Special controller card used in a crate to control, monitors and manages nested modules and Crate
functions, like switch ON/OFF of Crate power supply, monitor temperatures, fans, UPS and more
Module
Modular High Voltage Power Supply, plugged in a slot of a crate, supplied by a CRATE, communication
and management by CRATE CONTROLLER, no own POWER ON feature
Information in the row „module settings /device settings“ are module / device specific settings and are stored into the XML
configuration file. These settings will get lost when using
AUTO-CONFIGURATION
or
APPLY CONFIG
functionality.
11.3.1.
Ethernet configuration
The ethernet settings of the iCS server hardware (CC2x Crate Controller, iCSmini) can be changed under the
ETHERNET
tab. By
turning DHCP Client to enabled the iCS will try to obtain an IP address from the local networks DHCP server. Otherwise the IP can
be set fixed. Therefore DHCP client must be disabled and IP v4.0 settings can be entered manually.
ETHERNET FACTORY DEFAULTS
IP
DHCP
GATEWAY
empty
NAMESERVER
empty
DNS
empty
TIMESERVER
empty
11.3.2.
(Re)set / ethernet configuration
You can reset the ethernet configuration and also set to fixed IP adress e.g. cause of problems with DHCP IP relay using the
following procedure:
1)
Shut down all modules/devices and turn off the iCS System by unplugging mains.
2)
Create an empty file called “RESET_NET.txt” on a USB flash drive (FAT32 format)
3)
Now edit the file. It should contain the following entries, separated by new lines.
4)
Plug USB flash drive into the USB slot at the front panel of the device (CC24, iCSmini2, SHR)
5)
Plug in mains
6)
Please wait about 20 seconds until iCS has started completely
7)
optional: Plug off the USB flash drive and check on a computer if the file created on point 2 is still there.
Check if RESET_NET.txt was renamed into RESET_NET.txt.done on success.
CONTENT OF RESET_NET.txt
LINE
PARAMETER
EXAMPLE
DEFAULT-VALUE
0
IP address / DHCP
192.168.0.10
DHCP
1
NET MASK
255.255.255.0
255.255.255.0
2
GATEWAY
192.168.0.1
192.168.0.1
3
NAMESERVER
192.168.0.1
192.168.0.1
Crate Controller CC24/CC23 | Last change on: 14.04.2020 |
www.iseg-hv.com
25/44
