ISE 1-0009-000, Руководство по эксплуатации продукта

Страница: 22 / 45

ise smart connect Modbus Vaillant
Modbus TCP/IP
Order No. S-0002-007 Product Manual Page 22 (45)
4.6.3 sensorState
Value Description
0 No fault
85 Short-circuit
170 Interrupt
4.6.4 status
Value Description
0 Off
1 On
4.6.5 DTC_EHP
The “error number geoTHERM/3” is the error number displayed on the geoTHERM/3 controller.
Value Error number
geoTHERM/3
Description
514 30 Error comp inlet sensor
515 31 Error evaporator sensor
516 32 Error heat source outlet sensor
517 40 Error comp outlet sensor
518 41 Error heat source inlet sensor
519 42 Error HP return sensor
520 43 Error HP flow sensor
521 44 Error AF sensor
522 45 Error SP sensor
523 46 Error VF1 sensor
524 47 Error RF1 sensor
525 48 Error VF2 sensor
526 49 Sensor fault: TCoilLiquidOpen
527 50 Error heat source outlet sensor
528 51 Error condenser sensor
529 60 Error Heat source anti freezing protection : Delta T6-T7
530 61 Error Heat source anti freezing protection : T5<4°C
531 62 Error Heat source anti freezing protection : T6<-10°C
532 63 Error No water flow
533 70 Error Abnormal cooling of the C-H circuit
534 71 Building circuit: Floor protect. active
535 72 Error C-H flow temperature too high for floor heating
536 80 Error Compressor outlet overheat
537 81 Error Refrigerant pressure too high.
538 82 Error Refrigerant pressure too high. Check C-H pump
539 83 Error Refrigerant pressure too low
540 90 Error C-H pressure too low P14bar
541 91 Error Pressure brine too low
542 92 Error C-H return temperature too high
543 93 Error Fan overheat thermostat open
544 94 Error or two phase are missing
545 95 Error Wrong phase order
546 96 Error Refrigerant pressure sensors fault
547 20 Op Interlock: Heat source anti freezing protection : Delta T6-T7