ise smart connect Modbus Vaillant
Configuration
Order No.
S-0002-007
Product Manual Page 13 (45)
3.1
Configuration step 1
– IP configuration of the ise smart connect Modbus
Vaillant
By default, the ise smart connect Modbus Vaillant requests its IP configuration via DHCP. If the default
setting is used, a DHCP server will assign a valid IP address to the ise smart connect Modbus Vaillant.
If a DHCP server is not available for this setting, the device starts up after a short time with an AutoIP
address (address range from 169.254.1.0 to 169.254.254.255).
As soon as a DHCP server will be available, a new IP address will be automatically assigned to the de-
vice.
If it is necessary to use
static IP setup, go to the “IP network settings” page of the device website. On
this
page, you can switch from DHCP to Static IP Setup in the “IPv4 settings”. You simply unselect the
“DHCP active” check box to enable manual editing of the IP settings. The IP setup includes the follow-
ing parameters:
IP address,
subnet mask,
address of the default gateway,
an optional name server (if it is available from a different IP address as your default gateway).
After changing the configuration, you will have to save the settings. The device will then apply the
changes. Otherwise, the website will indicate and show you the incorrect parameter.
