SERVICE MANUAL
© ISA, s.r.o. 2014-2015. All rights reserved.
We reserve the right to change the specification without prior notification.
Always check for new version of this document@
Service manual V1.08 | Nov-2015 | LM0002-EN
Page 32 of 97
3.7.3
Configuration
AUX setup has to be performed via LVLØ mobile application in Service section. Select AUX, Lights and
Cover.
AUX1 usage: <countercurrent, waterfall, cannon, fountain, bubbler, jet, AUX1, not installed> define the type
of attraction connected to AUX1. To increase user experience, AUX1 icon on Home screen of mobile
application will change automatically. Select “not installed” when output is not connected, this will disable
button on the application Home screen. If there is different type of attraction connected than listed above,
please select icon which fits the most.
AUX2 usage: <countercurrent, waterfall, cannon, fountain, bubbler, jet, AUX2, not installed> defines what
kind of attraction is connected to AUX2. To increase user experience, AUX2 icon on Home screen of mobile
application will change automatically. Select “not installed” when output is not connected, this will disable
button on the application Home screen. If there is different type of attraction connected than listed above,
please select icon which fits the most.
Smart filtration start: <value> value in minutes. LVLØ is equipped with Smart filtration function, which can
automatically start filtration and water treatment processes outside of standard filtration time. When AUX
or lights will be turned on, filtration and water treatment processes will be started with delay defined in
this object. Processes will automatically stop after attraction or lights are again turned off. If you wish to
disable this feature, set 0 (zero) min.
AUX stop mode, attractions can be stopped in following modes:
Automatic: when attraction is started, it will be automatically switched off after defined time in
AUX autostop time.
Manual: when attraction is started, it will be running until manual stop by user input.
AUX autostop time: <value> value in minutes. This defines delay after the attraction is automatically
stopped when AUX autostop mode is in “automatic” mode.
After performing setup or any changes to this section, click „SAVE SETTINGS” to save configuration to
system.
3.7.4
AUX control via integrated switches and “AUX button” inputs
In addition to remote and front panel control, AUX 1 and AUX 2 outputs can
be controlled via integrated air switches or pushbutton connected to
“SWITCH AUX” outputs. These outputs can be freely assigned via LVLØ
mobile application.
3.7.4.1
Air switches
Two air switches are installed on LVLØ controller. These UL/CSA approved
can safely and simply switch on and off the contactor for particular AUX
output, even directly from a pool.
Air Spout Diameter = 4 mm, for 6 mm tube
3.7.4.2
Pushbuttons
Push Button Switches consist of a simple electric switch mechanism. To control AUX 1 or AUX 2 you can
use biased switches (momentary switch). LVLØ Controller is equipped with “SWITCH AUX 1” and “SWITCH
AUX 2” input connectors. These enable to connect switches with the "push-to-make" (normally-open or