Page 16 of 24
c)
Tighten the 4 inner Hex head screws being careful not to forget the spring washer. If
tightening the screws with an electric or pneumatic driver, check the torque of the screw with
a 12mm wrench (not included) to make sure
it’s tightened properly.
d)
If necessary, put glue on the screw and screw it in.
After Each Use
⚠
WARNING
Do not remove the chisel until it has cooled.
Store the tool in dry and clean place.
Keep away from children.
Maintenance
⚠
WARNING
Do not use solvents to clean the hammer.
Carbon brushes are consumable parts. When they become worn they can cause problems with
the motor. Use an auto-stop carbon brush which will stop automatically when the carbon brush is
worn, then replace the brushes.
If the supply cord of this power tool is damaged, it must be replaced and only by a qualified
service technician.
