8
STEP 6
STEP 8
A
.
After everything is square, make sure all nuts on the
system have been tightened.
NOTE: But do not over tighten the Nuts, make sure the unit
can be adjusted up and down.
B. To apply the Rim Height Sticker(H), first use a tape
measure to crank rim up to exactly 10’ from the playing
surface. Use a pencil to make a mark on the Spring-assist
Cartridge(E) where the bottom of the Rim Height Indicator(G)
stops. Then, peel and apply Rim Height Sticker(H) to outside
of Spring-assist Cartridge(E) lining up the pencil mark with the
10’ mark on the Rim Height Sticker(H).
C. Attach Post Pad and Gusset Pad to Main Post(A) as shown.
A. Attach the backboard to Main Extension Arm(B) by
using a 16mm x 29cm Hex Bolt(K), two 16mm Flat
Washers(U) and a 16mm Lock Nut(M). And then
secure the Upper Extension Arm(C) to Backboard
by using a 16mm x 26cm Hex Bolt(L), two 16mm
Flat Washers(U) and a 16mm Lock Nut(M).
A. Insert the 4 Plastic and Steel Spacers(V) into the 4
holes on the backboard.
CAUTION: Do not proceed with rim installation
without these spacers!
B. Mount the rim to the H-frame Backboard Mount(D)
and Backboard Assembly using the hardware supplied
in rim box.
NOTE: Use a level to make sure rim is level side to side
before tightening nuts.
STEP 7
V
K
U
U
M
L
U
U
M
K
H
