1.
GENERAL INFORMATION
Matrix
II EH
RFID
reader is used in Access Control Systems (ACS) to read contactless EM-
Marine Proximity and HID ProxCard II cards, and transmit the acquired card code via iButton
(Dallas Touch Memory) or Wiegand 26 protocols. The reader allows for cards of both EM-Marine
and HID
ProxCard II
standards to be used simultaneously.
2. MOUNTING AND CONNECTION
The reader should be mounted on a flat surface, in a place allowing unimpeded proximity card
access to the reader.
To mount the reader, perform the following sequence:
- Mark and drill the mounting holes, per Fig. 1;
- Connect wires to the reader socket,
according to layouts on Fig. 4 and 5.
-
Remove the thin tab in the reader case
, from the side where the cable must come out (Fig. 3),
and
feed the cable through this hole. When power is connected to the reader, the red LED will light
up.
- Mount the reader in the desired place and fix it with screws;
- Close the reader holes with supplied plugs (Fig. 2)
Note 1:
Do not install readers closer than 10 cm
one
from another.
Note 2:
To achieve the specified reader distance from controller, a CAT5e UTP cable must be
used (Fig. 5)
3. OPERATION
The reader operation without external indication control:
1. When power is supplied, in standby mode (no card present in the working zone), the LED
shines solid red.
2. On card approach, its number is acquired. If succeeded, the LED turns green for a short
time, then switches off, and a short beep also sounds.
3. While the card remains within the working zone, the LED stays off.
The external control for red and green colours of the LEDs and the buzzer is done by shorting
corresponding terminals (LED R, LED G, BEEP) to the common ground terminal. The external
indication control for one mode can be used with internal indication control for another; by default,
both the LED and the buzzer are internally controlled. After external indication control signal has
been activated (for example, for the LED), that indication goes under external control, while the
other (in this case, the buzzer) remains under internal control.
page 1
MATRIX II EH
www.ironlogic.
me
Matrix
II EH
ACS RFID EM-Marine & HID ProxCard II
Reader
(125 kHz)
User Manual
