IQ CV810, Руководство пользователя

Страница: 21 / 35

19
4. Network Configuration
4.1 Network Connection
Direct connection: Connect the camera and computer by network connecting cable.
Internet connection mode: Connect the camera to Internet by Router or Switcher and user can login the device by
browser web page.
Note: Please do not put the power cable and network cable in places where can be easily touched, to prevent
video unstable signal transmission due to poor contact of cables.
Add segment method:
The computer must have the network segment where the camera IP address belong to. The device will not be
accessible if without the segment. I.E.
The camera default IP address is 192.168.5.163, then segment 5 must be added in the computer.
Specific steps are as below:
Firstly open the window of Local Area Connection Properties on computer, select the “Internet protocol version
4(TCP/IPv4)”. Double click or click the property “Internet” protocol version 4 (TCP/IPv4) to enter into the
Internet Protocol Version 4(TCP/IPv4) Properties window; select “Advanced” to enter into the Advanced TCP/IP
Setting and add IP and subnet mask. Click the “Confirm” to finish the adding of IP segment. User can add the
corresponding network segment according to the revised IP address of the camera.
Note: The IP address to be added cannot be same with that of other computers or devices. The existence of
this IP address needs to be verified before adding.
To verify whether the network segment has been successfully added, click the “Start” and select “Operation” to
input cmd, then click CONFIRM and open DOS command window, ping 192.168.5.26 and press Enter key to
display information as shown below:
User can also to verify network connection as steps above mentioned after the finish of camera self-check. If IP is
default, open DOS command window and input 192.168.5.163, then press Enter key, It will show the message as
below, which means network connection is normal.