Gateway Quick Start Guide
10 Advanced configurations
10.1 IQRF IDE
The configuration of the gateway’s IQRF coordinator and the IQRF network with IQRF IDE is
possible via the Link It! management tool. The IQRF IDE can connect to the gateways via Link It!. At
first you should connect to the gateway with Link It! Described in section
. After that you can
connect to the IQRF coordinator with IQRF IDE as described in section
.
System architecture of how can connect and configure IQ Home gateways
CAUTION!
The IQRF IDE can connect to the gateway only via the Link It! by default for security reasons!
For development and/or debugging you can enable in gateway configuration but it is not
recommended in production use!
Follow the few steps below to connect to the IQ Home Gateway:
1. Open the IQRF IDE, open a project and choose “IQRF Device Manager” from the “Tools”
menu or press F9
2. Select Add UDP device icon
in “IQRF Device Manager” (or press Shift+Ctrl+D)
3. Select
Mode: IQRF gateway
4. Click on the
„Search”
button
5. Select your gateway from the list. If the list still empty check your network settings
6. Click on the
Add
button
©2022 IQHome Kft.
13 / 19
