IPOX N9000 Series, Руководство пользователя

Страница: 121 / 143

IPOX NVR N9000 Manual
IPOX NVR N9000 Manual
121
12.1.7 802.1X
If it is enabled, the NVR data can be protected. When the NVR is connected to the network
protected by the IEEE 802.1X, user authentication is needed.
To use this function, the NVR shall be connected to a switch supporting 802.1x protocol. The
switch can be considered as an authentication system to identify the device in a local network. If the
NVR connected to the network interface of the switch has passed the authentication of the switch, it
can be accessed via the local network. Protocol type and EAPOL version: Please use the default
settings. User name and password: The user name and password must be the same with the user
name and password applied for and registered in the authentication server.
12.1.8 NAT Configuration
Click Start
→
Settings
→
Network
→
NAT to go to the interface for NAT configuration. Check
“ Enable ” and then select the NAT server address. Click “ Apply ” to save the settings. You can
scan the QRCode through mobile client which is installed in the mobile phone or PAD to log in the
mobile client instantly.
12.1.9 FTP Configuration
Some models may not support this function.
Click Start
→
Settings
→
Network
→
FTP to go to the interface for FTP configuration. Check
“ Enable ” and enter the server name, port, username and password, max file size and remote
directory.
12.1.10 Platform Access
Some models may not support this function. This function is mainly used for connecting
ECMS/NVMS. The setting steps are as follows. Click Start
→
Settings
→
Network
→
Platform Access
to go to the interface.