Installation and Connection
28
9.1
Power supply of the CAR-A-WAN.112
The connection diagram (Fig. 4) and the following information must be
observed:
Fig. 4: Connection to the on-board electrical
system
Fuse:
2 times 1 A slow-blow,
each after continuous
plus and switching plus
Cable cross-
section:
min. 0.50 mm² / max.
0.75 mm²
Current (I) max
at 24V
Typical 700 mA, but
not more than 800 mA
9.2
Installation sequence
Assembly
Mount the CAR-A-WAN.112 and in such a way that it can be reached with
the power supply cable, see chapter 4.5 .
Power supply
Install the power supply cable, starting with ground, then "ignition", then
continuous positive, or plug the prepared and fused power supply cable for
the accessory socket into it.
Check the device for max. 30 seconds by applying voltage to the device.
The LED on the front face must light red; with the connection to the
Internet and the setup of the maintenance VPN, the colour changes to
green.
Disconnect the device from the supply voltage by releasing and pulling out
the plug by pressing on the top of the plug. Switching off the ignition is not
sufficient, as the device has a tracking electronics.